sailgre.blogg.se - Setup button box project cars 2 pc

Repeat until you have identified as many characters as you think you need (I suggest about 30, you do not want to use UP/DN/LEFT/RIGHT/2/4/6/8 as they are used for look left/right/up/down in the game already).

Using a jumper wire connect J1 pins to J2 pins (J1-1 to J1-1) and see which character is generated.

Open a program (I used excel and word) to record the keystrokes you will generate.

Make a table with J1 pins on the left side.

To identify the character generated by the pin combinations perform the following: Remove the plastic film-like keyboard inputs and remove the board from the keyboard housing.

Open the keyboard, and there should be a small board with two jacks that receive inputs from the keystrokes.

Sheet Carbon fiber (AutoM New DIY Carbon Fiber Wrap Roll Sticker For Car Auto Vehicle Detailing 1.27Mx30CM ($5.99)).

Ğlectronics project box (I used this one: Hammond 1591ESBK ABS Project Box Black (7.5” x 4.3”) ($7.51)).

Various buttons and toggle switches (see below for ideas).

Heat shrink tubing (multiple sizes as appropriate).

The wires are small and make it easier to solder to the surface of the board.) (I used phone line and separated the wires.

Old keyboard (probably can pick one up at a second-hand store if you do not have any laying around).

Heat gun (or lighter for heat shrink tubing).

I am waiting for 2 switches to come in that is why you see 2 holes in the box. Time: <1 day (Probably could be done quicker, but this is my first build and a bit of an experiment) I have only used this with pCars 2 on XBOX One. Here is my build for a custom button box.